Vent Cover


Since lowering the bathtub, the original vent cover isn’t long enough so I decided to make a new one out of the left over fiberglass I have.   I made the form out of birch plywood, applied a mold release, two coats of gel-coat and laid up two layers of fiberglass mat leaving the excess hanging over the edges.

Trimmed the excess off with my table saw and miter box.

I had to tear apart the form to release the part from the mold. Oh well, I didn’t need it anymore.

The new cover next to the old plastic one.  All that’s left is to cut it to length and fit it to the curved ceiling.

6 Responses


  • erotik // // Reply

    But wanna remark on few general things, The website style and design is perfect, the content material is really superb : D. Cacilie Terrence Chaille

  • sikis izle // // Reply

    I really like your writing style, excellent information, regards for putting up : D. Conchita Cullen Frendel

  • erotik izle // // Reply

    Enjoyed every bit of your article. Much thanks again. Much obliged. Keelia Vasili Keeley

  • film // // Reply

    There is certainly a great deal to learn about this issue. I really like all the points you have made. Gay Vernor Viole

  • film // // Reply

    I have been exploring for a little bit for any high quality articles or weblog posts on this sort of space . Phyllis Steve Hadrian

  • film // // Reply

    I wanted to thank you for this great read!! I definitely enjoying every little bit of it I have you bookmarked to check out new stuff you post. Hilda Hamilton Diane-Marie

Leave a Reply